1. Cut the tip off of
one of the fingers on the glove.
2. Place the small straw
in the hole made by the cut in step 1.
3.
Tape the glove around
the straw to make a good seal.
4.Place the sponge inside
the glove in the palm of the hand.
5. Tie a knot in the
open end.
1. Cut the large straw
to the length you want it.
2. Use the tape or the
clay to make a nosecone.
3. Use the tape or the
paper to create the fins.
The
directions for the rocket are not very specific. Experiment
with the length of the rocket, the size and shape shape of the fins nosecone. Also,
you may adjust
the launcher if you think you can improve on the design. See how far your
rocket can fly!!!
Launching
Your Rocket
1.Point the
small trraw on the launcher in the direction yo want the rocket to go.
2.Place your rocket
on the small straw attachet to the glove.
3. Hold the small
straw and press down on the sponge in the glove.
